The Transporter is a true vaporizer for aromatic blends. Its flask shaped external body is protected with a scratch resistant anodized shell. The high grade ceramic chamber utilizes an embedded heating element that provides high quality vapor in just seconds.
Using Your Transporter
Charge the Transporter – Charging the Transporter from full depletion could take up to 3 hours.
Load the Transporter – Loading the chamber is easily done by removing the mouthpiece from the Transporter connector, then filling the tank full with finely ground aromatic blends. Close the lid and turn the Transporter on. If the switch on the Transporter is locked, unlock by pressing the button five times. This enables the power switch and the Transporter is ready to use.
Power up and draw – Press the button for 2-3 seconds and wait for the light to turn green. Immediately begin drawing from the Transporter. Draw until you have had your fill. You may turn the oven off by holding the power button again for 2-3 seconds until the light turns off.
Since the Transporter has only one temperature setting, its essentially foolproof. Hold the button to activate the oven, wait for the light to turn green and draw until you have your fill or until the Transporter shuts off automatically after 10 seconds.
that melt into the Transporter’s heating chamber will likely ruin your device and void your warranty.
Varying your draw rate can effect vapor thickness, slowing your draw rate will create thicker vapors, and a quick draw rate will create slightly thinner vapors.
Since the Transporter has only one temperature setting, its essentially foolproof.
There is also a safety on the power switch, clicking it five times turns off the power button, and repeating this turns the button back on. This is great if you have the Transporter in your purse, or pocket, as it prevents it from going off accidentally and wasting your battery or worse.
As a general safety rule, do not leave the Transporter unattended while powered on.
At this time, remove the atomizer and connect the Transporter Battery to the Transporter Wired Charger (at the base of the Transporter). A red LED light will illuminate at the base of the USB charger to indicate that a charge is being administered.
Cleaning & Maintenance
The mouthpiece can be cleaned with the brush, or soaked in isopropyl alcohol until the buildup dissolves.
If you need to clean the outside of the Transporter, use a warm barely damp cloth. If the Transporter gets wet in any way, allow to dry in the sun or a warm dry area until COMPLETELY DRY. Attempting to use the Transporter if wet will cause serious damage to the unit.
Ordering – Returns – Warranty
If you have any other questions about the Transporter vaporizer, please contact us!
|Product Dimensions||5in x .38in x .38in (11.8cm x .97cm x .97cm)|
|Package Dimensions||7.25in x 2.5in x .5in (12.7cm x 12.7cm x 5.08cm)|
|Product Weight||.4lbs (.18kg)|
|Package Weight||.8lbs (.36kg)|
|Vapor Path||Ceramics, Rubber|
|Battery Capacity||2 x 2600 mAh Li-Ion||Voltage||7.4v|
|Auto-Off?||Yes, 10 Minutes.|
|Safety Power Switch||Yes, 5-Click|
|Warm-Up Time||20 Seconds|
|Country of Manufacture||China|
Included with Purchase:
- Atmos Transporter
- 100-240v Charging Adapter
- Rubber Mouthpiece
- Tamping Tool
- Cleaning Brush
- User Manual
Transporter User Guides
*Adobe Reader or PDF viewer Required
Getting the Most Out of Your Transporter
- Never leave a Transporter in a hot car.
- Do not allow the Transporter to Freeze. This will drain your batteries extremely fast. If you find yourself in cold weather, keep your Transporter close to your body warmth.
- Don’t allow liquid into the center tube when filling.
Cleaning the Transporter couldn’t be easier. The inside of the mouthpiece will take on the most buildup, soak it in isopropyl alcohol and clean with a cotton swab if needed. Never bring liquids near the Transporter itself.
The included brush should be able to remove any collected debris.
Need Assistance with your Transporter?
Try these solutions to common issues:
Are you getting any light at all from the button or the bottom? If not, make sure that its charged properly.
If you have charged it fully and unlocked the power button, and are still getting no vapors, remove the mouthpiece, press the button, and see if you feel any heat.
If these troubleshooting tips don’t work, please contact us.
Atmos Transporter 5 Year Warranty
Vape World is handling all of the warranty requests and service for the Transporter.
*IMPORTANT: WARRANTIES NON-TRANSFERABLE. ITEMS PURCHASED ONLINE FROM E-BAY, AMAZON, CRAIGSLIST, ETC. ARE CONSIDERED 2ND HAND AND WARRANTIES NULL AND VOID!
If you need more information about Transporter’s Warranty, please contact us